If you would like to replace your old Wifi router or avoid making monthly payments from a leased Wifi Router rented out by your ISP then you should use your PrivateRouter as the only WiFi device in your network.


In a single router setup, the PrivateRouter will be wired directly to your cable or DSL modem via ethernet cable and will be the only Wifi router in the setup.

After plugging in all devices  power off your ISP modem and PrivateRouter then do the following:

• Power on your ISP modem and wait for it to fully boot up.
• Power on your PrivateRouter
• Connect to PrivateRouter Wifi, enter the default password “torguard” and browse to 192.168.8.1

 

Ця відповідь Вам допомогла? 1 Користувачі, які знайшли це корисним (1 Голосів)

Найпопулярніші

How to Change your OpenWRT Admin Password

It is important to change your WiFi router's admin area password to a strong password.  1. To...
Adding Your PrivateRouter with a Dual Router Setup

If you would like to keep your existing WiFi network as is, and simply want to add a...
How to Setup a Secure WiFi Password

To change the PrivateRouter Wifi password first access the admin area at 192.168.8.1. Click the...
How to Connect Your PrivateRouter to an Existing WiFi Network

At times you may not have physical access to an existing router to gain internet and plug in a...
Using Watchcat to Guard Against Downtime and Disconnects

To protect your network against ISP network interruptions or unforeseen VPN disconnects it is...